In opposite directions? No I havent

I can't find the fucking webpage.

https://www.thefirearmblog.com/blog/2018/06/21/sirca-tec-slf-x-pisol-crowdfunding-project/

FOUND IT

MY GOOGLE FU IS UNSTOPPABLE

@Seatoast, check this shit out. ^

Pretty neat

Also: FUCKING ALUMINIUM SLIDE

WUT

That is how amazing the mechanism is, you can make the fucking slide in Al.

@Seatoast https://gundynamics.com/products/sircatec

Now THIS is a REAL MAN'S crowdfunding campaign.

Back it to get a gun, that's 'merican.

In my mind the most exciting thing about 3d printed guns is their potential to make any gun control legislation a moot point.

In Cali, they are going after the ammo.

Those are probably easier to make than a gun. Building your own foundry is pretty easy, and bullets and associated materials aren't big.

Cartridge extrusion, however, is not easy.

(Not easy to set up at least.)

tfw you'll never be a bad ass camel cannon soldier

If you already reload casting your own bullets isnt that difficult. The problem is the cases themselves

Primers as well 🤔

You could stock pile them but if you're already doing that may as well just buy up rounds

Lead Styphnate and especially Lead Azide are not particularly easy to make.

Although making tooling for primer cups would be comparatively easy.

Anvil a little harder.

http://i.giphy.com/l0O9xPWfaccWTBas8.gif

good ol'Ian

https://youtu.be/oU_sOb7Fkdo

what the fuck

Raw vulgar power

@Chaos Marine Would you mind linking Ian's vids on full30 rather than youtube?

What?

https://www.full30.com/channels/forgottenweapons

Oh, I did not know that existed

I guessed.