At least PSA uppers are assembled by citizens *i hope*

@Bogs_Bunny Yeah, I don't have anything higher than 9mm.

BCA really that bad? I'd prefer separate parts and put the shit together myself. If assembly is the concern vs quality of parts at least.

And just think how they build them when no one is filling

Bear creak is the surefine foods of the AR world

What's wrong with how he built it?

Idgi

Not enough pipe wrench

Then again I've never put together an upper

😳 all of the things. Literally all of them haha.

I've never put together an upper either. I'm looking at prebuilt complete uppers most likely. Edit: I've never put together any gun for that matter.

That’s probably wise unless you have the tools, knowledge and patience to build things correctly.

Someone should tell that to BCA

Buy a parts kit from 22mods4all and a 12” pipe wrench

Assemble upper

EZ PZ

pls do not do that

If you’re concerned use red loctite everywhere

also pls do not do that

Use blue rags if you’re concerned about marring

Or the correct tools

We’ve already went over the pipe wrench

If I submerge the entire gun in a vat of red loctite I should be good to go

Use corks for the barrel

And then yes

This is why I can’t sleep at night

Melatonin helps

What kind of whiskey is that

If I buy a Dremel I'm basically a gunsmith right? Trolololol

Don't forget ye' trusty hammer

Mmm BCA

Oh boy... quality

You see this? Big tool doesn’t want you to know this but this is actually a hammer

@Crye_Salesman What the shit did you do to it?

No way in hell that's from normal shooting. That damage looks like it was either ran over by a vehicle or it had one spicy reload attempted to run through it.

Wtf happened to that rifle

I'm guessing hot reloads. Especially after looking at the BCG.

Not mine, stolen off FB. Factory 300blk. My personal suspicion is that part of the ruptured cartridge was stuck in the chamber, and it detonated partially out of battery.

honestly not the worst oob I've seen by a long stretch

No