Message from @FRISKY68WHISKY
Discord ID: 714523374549729311
I really like the other one
https://beasts-tactical.com/collections/frontpage/products/tactical-beasts-ballistic-helmet
This isnt a real ballistic helmet I don't think but God damnit it's cool looking
Oh the meme ones are in <#704438986378051614>
*replying to @Abe Clark
That would make a decent bump helmet
Definitely @Fabultishere, especially for Match/defensive ammo
New World Order Riot Control Force helmet right there
Just keep in mind, it isn’t really ballistic *if you know what I’m sayin* @Cannibalistic69th
It's not even rated as a bump helmet and the lenses aren't ANSI rated either... total larp gear. Cool, but china garbage
Oh I just meant *penetration*
It's literally an airsoft larp helmet, it was a big hullabaloo in the AS world a few months back when the manufacturers tried to claim all sorts of specs.
I know I almost bought one lmao
It does look cool though
I was 👌🏽 close to picking up one of those helmets lol
Sticking with my boonie 🤷🏽♂️
Check out the team wendy stuff with the mandible and riot lens though, not quite as cool, but if you have the cash functional
Hmmm. Maybe I will. thanks man.
Scrolled past this on Facebook
Well said honestly
Cav scout must've wrote that, all that 11B bashing lol
Saw it on tacticool memes page. They tend to share some really reasonable stuff when it comes to best practices, also making fun of people who do things like small of the back carry a rock arms 1911 without one in the pipe in an uncle Mike's holster
That was painful to read
I like my ACOG
They're really simple and there's nothing wrong with that. You don't have to worry about fiddling with anything. Only real issue is the eye relief.
^ yea. Still can’t believe trijicon hasn’t made there accupoints with any of the ACOG reticles
A lot of the acog reticles are better suited for fixed power or 0 power optics
The Anderson finally died, firing pin retention pin broke and the firing pin dislodged and the bolt is now stuck forward
You can pull the barrel offand get the BCG out the front
I got it out but that's just the assement of how it finally malfunctioned/killed itself
Ah
Anderson lowers are fine, uppers too for that matter... it's the internals I always hear issues with
Which one of you has the slideshow of Anderson failures? Add this fellow haha
The only parts I've had issues with consistantly are the take down pins and the extensions on the upper they go through, always wobbly even though I damn near have to hammer them in
That's the pins more than likely
It was @Artemis, what a champ
The pins are to spec, and the pin holes are too, I think the extensions off the upper are a tiny bit too narrow
Yeah that took me forever to make lol
Basically scoured the ar15 forums
Because of the materials used in the upper and lower, structural integrity is probably okay but the tolerances are so bad, and stack on top of each other, that they can cause issues which lead to catastrophic failure
mine also has a rifle buffer crammed into a carbine length buffertube