Message from @Abel
Discord ID: 501921996582551552
Perhaps I should interject given it was I who was asking for suggestions. Scribble, I appreciate what you think you are doing. However, your suggestion (s) amounts to a meaningless platitude(s). So at this point, I'd have to say that I find your insight to be slightly less than desireable. I appreciate the effort though.
I donβt really understand laser printers as much
Maybe you can be Timmy's coffee bitch when he's big, he would treat ya good @Scribblehatch π
Do they skip the need for ink and toner?
They shoot lasers
They use toner. π
What
Fused to the page with the laser.
Then I have to buy toner
Don't you think it would be ever so slightly dangerous to etch *paper* with lasers?
π
No
Oh, okay. Well mine uses toner.
We need to make paper out of pure steel
I think that's the most common type. But I'm sure you could find the type you prefer.
The paper comes out warm. But it's not going to start on fire.
Printer that etches stone tablets.
This seems the best tech
A hammer and chisel printer
@R9b1t yeah
@Malt_Hitman It uses lasers to melt plastic to the paper, so it's entirely reasonable for it to come out a bit warm.
3D Chisel Printer
@Malt_Hitman Political parties in the UK are structured a bit differently, and it would be very unusal for somebody like dankula to be directly employed by them.
Do y'all niggas know how slow printers used to be.
By all means. Enlighten the group scribble
Pretty much as xorgy says
Yeah I'm old
UKIP hasn't employed dankula though
Dankula had a job even during the case, he worked at a tattoo parlor.
He's just a member
Also last time i checked ukip was almost bankrupt
Sure but Iβve never used one because when you think about it printers will be phased out soon
He no longer does because he can do youtube full time.
This printer speed was standard until like
@Coochie coo so do I but I'm ready to be educated by someone who most likely doesn't remember it.
The early 90s.