Message from @Kaytee
Discord ID: 501517557514108938
multiple areas that seal against the canal
so you get a better seal and higher isolation
issue is that bi/tri flange tips are often longer, which will affect the sound
whether the affect is positive or negative is entirely down to the iem and your own preferences
And then there is opening up an iem and closing it with tape/cotton
buy ety or diy using shady taobao BA's and 3d printer at uni
🤔
I even have female mmcx jacks
might just diy it
ull want the knowles filters as well
I'll order these today.
https://aliexpress.com/item/YINCROW-RW-9/32868456063.html
yincrows r good
I liked the x6's, I think these are mostly the same but better built.
apparently they sound slightly better too but i havent confirmed
cable is definitely upgraded tho
etys
bluetooth
plz
buy mmcx ety friend
@Windatica unless you're using an sla printer, 3d pritned iem enclosure will take a _LOT_ of post processing to work well
there's a few jet 3d pritners on the market that'll be good enough too but your uni prooobably doesn't have one of those
they cost millions
i really fucking want an hp jetfusion setup but i'll never be able to afford it :<
>makerbotted iem enclosure
yeah just kill yourself now
dlp is a subset of sla, the other main tech is using a scanning laser to cure resin instead of a movie projector
plenty of unis have binder jet printers but you're right they'll be expensive af to use
you could probably make a KZ BA10 enclosure on a manual mill without too much thinking though :^)
ive printed iem shells before without issue
they dont look fantastic but they held fine
same but with my entire existence
You painted your entire existence and it didn't look fantastic but it held fine?
<:turt:443131018950606878>
@crackedpepper those cables look awful
the strain relief makes me want to cry
wtf is that
80$ earbuds.
I want something serious, under 110$.
Because that's what I paid for the dap.
lol $$$ earbuds
Not going to dump more money on the earbuds than the dap, that's foolish.
lol