So it compresses your ear drum?

https://puu.sh/BLujX/3ba015d9f0.png

Kek

you can avoid that by just yawning

same way you pop your ears when youre in a tall ass elevator or whatever

Hol up the beat is about to drop *Yawns*

Good boy 12

Pressure would build up in part 2 but I guess the depressuring of 12 would reverse it?

ye

also the seal isnt perfect in iems anyway so itll depressurise over time

its pretty much irrelevant if you insert your iems properly anyway

like etys are 100% sealed and i dont have issues with ear pressure shit

Yeah about seals, is double flangle or some other seal meme worth it?

Only a single tip doesn't seal properly

depends on the iem and your ear

Actual benefits for wearing more than one flangle?

Some headfi's claim it chances the soundsignature

multiple areas that seal against the canal

so you get a better seal and higher isolation

issue is that bi/tri flange tips are often longer, which will affect the sound

whether the affect is positive or negative is entirely down to the iem and your own preferences

And then there is opening up an iem and closing it with tape/cotton

buy ety or diy using shady taobao BA's and 3d printer at uni

🤔

I even have female mmcx jacks

might just diy it

ull want the knowles filters as well

I'll order these today.
https://aliexpress.com/item/YINCROW-RW-9/32868456063.html

yincrows r good

I liked the x6's, I think these are mostly the same but better built.

apparently they sound slightly better too but i havent confirmed

cable is definitely upgraded tho

etys

bluetooth

plz

buy mmcx ety friend

@Windatica unless you're using an sla printer, 3d pritned iem enclosure will take a _LOT_ of post processing to work well

well, or dlp, basically you want one of those fansy resin pritners that'll do 25 micron layers

there's a few jet 3d pritners on the market that'll be good enough too but your uni prooobably doesn't have one of those

they cost millions

i really fucking want an hp jetfusion setup but i'll never be able to afford it :<