Message from @shadowedROM
Discord ID: 277116560873619457
yep
hotbed at 45/45
Got a voltmeter / -ammeter to test?
sadly not
Barring that, one would assume the extruder died, but a multimeter is both cheap and arguably an essential piece of kit
I'm not so sure extruders can fail in this way
apparentlly heat cartridges can overheat
but what did you print so far :x
nothing, but it heated up once
Yea I saw from above
But it's at like 16-18'C now right
25
If I were you neighbor I'd run over there now to test your output leads from the board :/
Did you strip the ends
yes
The sucky thing would be a dead board
Just checked, the wires seemed to be rip so I stripped them again and made sure it connects
If it's a dead extruder head then it's just an excuse to upgrade early
didnt work though
Did you try manual temp setting
yeah
"Heat PLA" etc ok
heat pla doesnt do anything
setting temp to 190C and returning resets
Weird
when I get into the Extruder Menu it says
Extruder 0 Off
And you've tried resetting too right
How?
Just power cycle I mean
http://i.imgur.com/nCoSZjf.png REEEEEE
yeah
This is part of the "fun" and learning but yeah idk we can pussyfoot around testing the board itself but when it comes down to it you need a meter
im getting one tomorrow
still sucks because it used to work
and I have no idea how to access error logs
Unsure if logs would be useful
Do you have a temp probe? I'm assuming that's how you checked the thermistor
I dont