Message from @shadowedROM
Discord ID: 277117064672706560
But it's at like 16-18'C now right
25
If I were you neighbor I'd run over there now to test your output leads from the board :/
Did you strip the ends
yes
The sucky thing would be a dead board
Just checked, the wires seemed to be rip so I stripped them again and made sure it connects
If it's a dead extruder head then it's just an excuse to upgrade early
didnt work though
I've heard gearbest may ship replacement parts if you bought it from them
Did you try manual temp setting
yeah
"Heat PLA" etc ok
heat pla doesnt do anything
setting temp to 190C and returning resets
Weird
when I get into the Extruder Menu it says
Extruder 0 Off
And you've tried resetting too right
How?
http://i.imgur.com/nCoSZjf.png REEEEEE
yeah
This is part of the "fun" and learning but yeah idk we can pussyfoot around testing the board itself but when it comes down to it you need a meter
im getting one tomorrow
still sucks because it used to work
and I have no idea how to access error logs
Unsure if logs would be useful
Do you have a temp probe? I'm assuming that's how you checked the thermistor
I dont
If the thermistor was DOA in the first place, maybe it overheated, but you say it works
fauly thermistor should show up at 0 or def
also the hot end doesnt heat up, im sure
i can touch it
If you have a bench power supply you can test the thermistor in isolation
At which point if it failed open a trouble ticket with the chinks you bought it from or get an upgraded extruder locally if you can
We sorry hotend not thermistor
Er*** I haven't had coffee yt
I read that an LED should light up once it's heating and that works
So I guess the boards not faulty