Message from @Kaytee
Discord ID: 389147061783887883
yeah and then you have to restart the fucking service 50 times until it works again
yep
and when you finally do get it working at all, whoops now your drawing software of choice isnt talking to the driver
gotta restart that and hope you can maybe find your way back into a groove
Im gonna buy a thicc laptop stand from chyna
woo, orange pi r1 is here
what're you using that for?
was gonna use for somewhat fancier network tap, but i'm kinda feeling making a router out of it now
it'd be a shit router but w/e, shitty internet connection and my switch is fancy enough to make up for it on the lan end
fuck I hate my redmeme note 3
retarded ass xiaomi doesnt allow you to install apps on sd card
Wiki is down, whats a good charger for 18650s that won't burn my house down?
liitokala
sounds finnish
or gb with coupons
Thanks, the zanflare z1 I got has built in charging but its really slow
It'll be handier to just swap out batteries
tbh, if you wanna go super cheap charging 18650s
assuming you're using common chemistries, ofc
yeah that one liitokala is like 2$ with coupons sometimes
w/o cell
ye but this one is like 20c
the little tp4056 boards are gr8
cheap enough to have one for each battery
Midget batteries? Boo!
nobody even makes good 18350s
What's so difficult about just chopping an 18650 roughly in half?
Those boards look ideal for putting into worklights, I have a couple that run on AA atm, It'd be pretty nice to convert them to rechargeable 18560s
>can only discharge at 1.8A
>like 6W max
well, let's round up and say 7W
either way yuk
and at 7W a brand new one will be dead in a half hour
@Hanzer nah alkaline is way more energy dense than this, AA is 2500+mAh capacity
better for worklights than a lithium 18350 outright
i'd maybe get those fancy iron disulfide batteries in 18350 though
but those are primary cells
Wat dis
A bag