Message from @Dustin
Discord ID: 383868125742891014
You can pm me to if that works.
@Dustin @ashrob NJ Great looking work guys
These are what I'm issuing to weigh down my banners.
Usually found near the lumber section @ home depot.
Are you using Two plates and a bolt and nut?
Just 2 plates, 1 for each corner. Secured with a strong zip tie.
Maybe a little duct tape.
You can punch 4 holes in the cloth and use 4 zip ties on one plate
One moment...
I found these @ different sizes in a different hardware store - Orchard hardware. And they were cheaper in-store than the website says for some reason. Grommets already installed.
If it has grommets then your set.
Just make sure you have large enough zip ties or use multiple
I could only find large plastic ones, they work well. Very strong. I want to try metal zip ties - they might be harder to cut.
Make the entire banner out of sheet metal.
Weld the letters on
xD
Metal and cable is difficult to work with if you aren't used to it
Big brain Thomas always has the right answers
Make the banner bright green, so folks can see it better, maybe use some of that reflective paint, too. Might need to switch the lettering to white to make it pop out more. Add that onto the sheet metal and we should be good to go for a banner.
So make a racist road sign
It will fit in your TRUCK if you don't drive a supper duty then your a faggot
👌
Yfw not a Texan Master Race
***LOCAL SAN ANTONIO MAN IS UNSTOPPABLE***