Message from @Zuihou
Discord ID: 495655388125986831
That is wan
From what i asked, that is a warning, not an error
I found that one too, last post is a "fuck it"
yeah
Will not cause eth0 to drop
basically if your config is correct, then it seems like it doesnt matter
but your config might be incorrect
what router do you have?
It is a dhcp mode to pick up ip from the modem
@Grenade123 unifi usg
have you tried restarting it by chance?
Yes
Now get this, isp modem showed a restart on the same time as my eth0 goes down
tried resetting the dhcp?
>but random restart is not indicative of hardware failure
@Grenade123 you mean the modem dhcp server
It gotnpower cycled
Wan is having issie
Different
Dhcp is to correct lan issues
But wan is handled by modem
Otherwise you will have modem acting as router and router being router, you will get 2 routers
It does look like a DHCP client issue involving eth0.
Not really
Their modem gives a private ip on startup, then gives a public ip on link establish with internet
"?Looks like the dhcp client under eth0 made zebra thinking the broadcast address wasn't right. If WAN/Internet access is fine then there isn't much to worry about. You can try renew dhcp for eth0 see if the message would occur again, also you can check "show interface ethernet eth0", "show ip route", and "show ip route forward" outputs see if anything doesn't look right"
It is still routing fine since internet worked for days on end
that was from the post i linked earlier
but on a different note, have you tried power cycling the modem?
and any other routers on the network
Yes
The error was after the power cycle, about 1 hr after
Where on earth is it getting '255.255.255.255/24 != 82.xx.xxx.xxx'? The IP settings on eth0 must be jacked up.
Dhcp from isp is stupid
It goes from private to public
I read that as ICP
I'm like
the fuck do juggalos have to do with this