Message from @Anticom
Discord ID: 499016190589665291
Center punch the hole for the drill bit and rock and roll
Especially after you already cut out all the stuff in the middle you have to
I mean yeah, centerdrilling and drilling it out would probably give you a much better result
Not even a center drill. Just punch mark it
I know with the Polymer 80s, they come with all the bits you need don't they?
Yeah but he is probably doing an ar15
Poly 80s you can do with a drill
Poly 80s you can do with a dremel in a pinch
You can for sure use dremels
The holes will be shit more than likely if you try that tho
Nope
Lock it in a vice and don't plunge it and you'll be ok
Well with the P80 yeah cause it has the holding piece with the drill guides
But anything else is a crapshoot
Probably all the handguns but 1911 molds would be fine
Don't try on a rifle
Exactly
Ty for advice
I'm not doing an 80%. I'm trying to machine ak trunnions
Oh.
because I'm not payinng $200 for one of those
The ultimate weapon
🥜 💦
👉 👌
Comitt weld
IT IS
Needs rivits
And basically just assembly
Oooh, is that an m53?
no
its a mg3
Oh
@Sadmin I think my Smith could build it
Texting him rn