Message from @Anticom
Discord ID: 499014759207665684
Endmills don't like doing the work of a drill
I don't see an issue with plunging it
Center punch the hole for the drill bit and rock and roll
Especially after you already cut out all the stuff in the middle you have to
I mean yeah, centerdrilling and drilling it out would probably give you a much better result
Not even a center drill. Just punch mark it
I know with the Polymer 80s, they come with all the bits you need don't they?
Yeah but he is probably doing an ar15
Poly 80s you can do with a drill
Poly 80s you can do with a dremel in a pinch
You can for sure use dremels
The holes will be shit more than likely if you try that tho
Nope
Lock it in a vice and don't plunge it and you'll be ok
Well with the P80 yeah cause it has the holding piece with the drill guides
But anything else is a crapshoot
Probably all the handguns but 1911 molds would be fine
Don't try on a rifle
Exactly
Ty for advice
Oh.
Well, more specifically I'm trying to machine the 4.5 mm sidefolders
because I'm not payinng $200 for one of those
The ultimate weapon
🥜 💦
👉 👌
Comitt weld
IT IS
Needs rivits
And basically just assembly
Oooh, is that an m53?
no
its a mg3
Oh
@Sadmin I think my Smith could build it
Texting him rn