Message from @Ondsinet
Discord ID: 508121155073212464
That's better
for me its $235 right now
im somewhat okay with just printing ugly functional stuff on it
No way dude
i was looking at amazon
It's great quality
The resolution would be 0.06 mm to 0.3 mm
But you can easily change the nozzle
Bigger or smaller
That is the standard for pretty much all
Printers for that range
Unless it's some small and very detailed figurine you will never need less than 0.1 mm
id love to make some figs but i can wait
You can make them alright
im still trying to figure out where i could even keep the printer
Dude fuck
It's 4:30 in the morning
nice gun
hate the shine on that white filament 🤢
ez
It's in the pictures
Photos
It's not there, I was using flash
LGR is good wholesome stuff.
why is this in comp sci
3d printers
Should be in <#485861475462807562>
Agreed. I'm not gonna spawn stuff, just wanted to show that the 3d printer the dude wanted to buy can do some fine prints
lmao
I might buy an ender3 after xmas
I'm trying to solder a prototype shield together with IC & terminals, and I have no 22ga or any decent colored wire, so I'm manually trimming and stripping jumper cables with straight clippers, tinning the tips, and then soldering those anemic little whisps onto my protype shield, and I am on my second blank shield, cause I already screwed it up once
I hope god comes back to earth the kill us all <:pepe_hang:460603218766987298>