thank you

still no solder wick yet

<:pepe_why:378719408367075333>

The 4 grounds on that ic are there to allow it to sink more current

And the datasheet says for heat dissipation so I guess you are supposed to leave a good blotch of solder to act as a makeshift dissipator

A capacitor there won't cause any kind of stress

it says it wants some copper down there, or a grounded heatsink. mine's not getting that hot but im gonna up the voltage, and then later im gonna stack these bitches for the hell of it

Found a photo of my l283d ic setup

did you had to make your own breadboard?

Did you had

I just like to have things nice and clean

Compare to your jumper jungle lol

fuck if i noticed, my whole room looks like that

in all seriousness i have used some extra wires to make some connections more accessible to pull out later

theres a lotta ways to make a pasta

That board has connectiona for:
2 motors
4 enstops
1 rgb led
2 buttons
1 RFID board

And they all neatly plug in

Btw we're gonna have tanks, boats and drones

<:pepe_smug:378719408341909506>

need tank shipping boat

/helicarrier

is that paint pen on the headers?

Sharpie

And gnd

well that shows up nicely for a sharpie

Needd to give instructions to unskilled workers that would have to assemble it later

(me from 2 days later)

kek

how about them blue rectanguloids in between the ceramic caps and the ancillary header?? that some weird cap ive never seen before?

"weird cap" it's just regular capd

>blue retanguloids
I'm using that term with the children from now on lol

use lots of funny tech memes in teaching

knowledge wrapped in a joke

keeps the little shits attentive

More like

FRA

Go get the blue retanguloids from the shelf

FreeRange Autism?

Francesco for short