of course theyre all connected 😄
thank you
still no solder wick yet
<:pepe_why:378719408367075333>
The 4 grounds on that ic are there to allow it to sink more current
And the datasheet says for heat dissipation so I guess you are supposed to leave a good blotch of solder to act as a makeshift dissipator
A capacitor there won't cause any kind of stress
it says it wants some copper down there, or a grounded heatsink. mine's not getting that hot but im gonna up the voltage, and then later im gonna stack these bitches for the hell of it
Found a photo of my l283d ic setup
did you had to make your own breadboard?
Did you had
I just like to have things nice and clean
Compare to your jumper jungle lol
fuck if i noticed, my whole room looks like that
in all seriousness i have used some extra wires to make some connections more accessible to pull out later
theres a lotta ways to make a pasta
That board has connectiona for: 2 motors 4 enstops 1 rgb led 2 buttons 1 RFID board
And they all neatly plug in
Btw we're gonna have tanks, boats and drones
<:pepe_smug:378719408341909506>
need tank shipping boat
/helicarrier
is that paint pen on the headers?
Sharpie
And gnd
well that shows up nicely for a sharpie
Needd to give instructions to unskilled workers that would have to assemble it later
(me from 2 days later)
kek
how about them blue rectanguloids in between the ceramic caps and the ancillary header?? that some weird cap ive never seen before?
"weird cap" it's just regular capd
>blue retanguloids I'm using that term with the children from now on lol
use lots of funny tech memes in teaching
knowledge wrapped in a joke
keeps the little shits attentive
More like
FRA
Go get the blue retanguloids from the shelf
FreeRange Autism?
