Message from @M4Gunner
Discord ID: 510109739536089088
I tried to cover it up
With my shirt
@Deleted User barely. i ripped this out and redit it with solder. But I have to redo it to add caps and im waiting on freegin solder wick to get here so I can undo these boards
https://cdn.discordapp.com/attachments/226937100707037194/509284448202784778/20181106_003336.jpg
https://cdn.discordapp.com/attachments/226937100707037194/509284748175212544/20181106_003404.jpg
M
no
@Deleted User im working on getting a servo working to aim a laser pointer diode
Redo?
the eyes are moving
Who is that
I recognise that guy but idk
But seriously it's just two Lm293 or what? Why such a big mess for that?
is it the guy from looper?
Don't get stuck on those shields that put 300 components on a shield to justify their (excessive) cost
its one L293, 4 pins(plus power) for PS2 controller, 4 pins for a little 3-LED status light
I remember just soldering the enable to vcc because what's the point? Still looks way too many wires man
and theres a bit of extra wire on some components to make them easier to unplug and fuck with
You just use pwm on the direction pins
if i could pull these headers off the top i could have soldered more stuff to GPIO pins, but then id need to change pins later
I love the jump from trap feet to diodes
okay is there no reason to do it one way or the toher? i was just trying to do it the way thats most common
diodes > trap feet
You save pins
Arguably
true
i'd need both motor pins on a PWM pin then right?
Could eat both. Don't quote me on that
No
Just one
im a little confused about that, why only one?
Comp sci
@Deleted User it's pogo
What pogo?
<:GWfroggyPepoThink:400751114221256705>
lol