Message from @zambz
Discord ID: 333358443018584065
thanks goybest
fucking end my life
wanna see a fully retarded headphone amp though
what are amplification stages?
@Windatica please gibe impressions
@Windatica pained_audiophile.webm
@Goa cmoy is generally as good option, if you wanna look at tubes and get that tube noise injection little bear is like $60 and has a tube preamp
's actually just 5532 driving the headphones though so it doesn't have the output current for any really high impedance headphones
neither will most cmoy variants
now I can have even better airflow
@Kaytee okay thank you. I will however try to find something already assembled along with the dac.
or seperate but buy both
fiio e10k
a bit expensive
i'm not too big on combos so i can't vouch for the amp in most of the budget ones
i can solder, no problem
shorten links
tpa6120, it'll be great
you are right sorry, i was doing it in a hurry
do be aware it probably won't come with schematic though
so you basically just have to know how to make an amp anyway
good point
not a bad deal for $18
cheaper than you could reasonably buy the components for just one finished amp on digikey or whatever
shit those heat sinks would run you like $2 a pop easy if not more
that pot's $2 in quantities of 1
also i'm not sure how assembled it comes, do be aware the tpa6120 is a small surfacemount part
so get your drag soldering tip ready
and it might even come in the QFN package, and if so get your hot air station / reflow oven ready
i do have all that
only a true wizard can hand solder qfn packages
got a solder stencil for 20-pin qfn?
thing's 4mmx4mmx0.5mm, not exactly gonna do that with a spool of solder hot air station or no
need paste and stencil
Would the Behringer UMC22 be a good interface to go with a NW/BM-800? I'm looking into moving away from my gaming headset, but I also don't want to blow the bank, and I hear USB mics can be a pain