Message from @tgotr
Discord ID: 358714965676392455
16A minimum, but honestly if you aren't putting 20A through that bed you aren't getting much use out of it for the plastics that it helps
depends, you have 12v and 24v pritners, most are 12v
Ah ok. Well shit, I have a ton of 12v 20A PSUs from laptops
all the beds can run on either and i would actually recommend getting a 24v supply to run the bed and maybe just give it its own controller instead of having the 3d printer control that
you'll get same power with less current
if you use a psu for just the heat bed, make _absolutely sure_ it can shit out absolute minimum 16A indefinitely, and you really want 20A
if you're gonna use it for the whole printer, 25A-30A
OK
a lot of people use gaymurr psus for this
Not all materials require a heatbed so. Maybe a separate PSU is in order
since they all have multiple super high current 12v rails and big chunky connectors meant to handle lots of current
most require a heat bed
you're limited to PLA and PVA without one
Yea, and PLA is shit
it's got pretty good wear resistance but for most applications i'd rather use abs or nylon, yeah
it's also got some surprisingly good chemical resistance, better than abs at least
gonna have a hard time attacking pla with any solvents normal people will have on hand
Acetone smooths out PLA if I remember right, the fumes at least
pla ighnores acetone
acetone smooths out abs though
well, ignores, if you let it soak in acetone it will very very slowly attack it
but you'll see it soften and delaminate, not dissolve smooth
it just kinda goes rubbery and the bonds between layers break
ah
On the waiting list for the delta.
what are some cool chink shit musical instruments
apart from melodica
how do you look at your recently viewed items on gearbest
i swear, sometimes i think i'm actually retarded
find it?
that's what i'm trying to do
history?
oh shoot good reminder i should get one
also kazoos
ukelele and kazoo so i can do bitches aint shit played at 300% speed
i saw that
looks kind of cute @Tribit