Message from @HEKTIK
Discord ID: 366068988012134420
@Deleted User abs fumes are super bad. Both for you and the environment. Pla is bad too but not as bad and easier on the environment. Abs is better material and sturdier just will give you lung cancer
@johnfrum#8811 you would just fan it back into the room
Ah I see
Through a window.
Also ABS off gassing is new car smell, no idea why people play up the hazards so much.
Wait
Could I make ABS filament recycling car interior parts?
Maybe? Heating process to remelt it will probably break it down pretty badly.
Also good luck getting consistent filament diameter.
ever heard of crushers? 😃
Actually a heater strip hooked up to PID set at the plastic stage of ABS wrapped around insulated seamless tubing might work if you have an additional source of hydraulic pressure.
It would be just like a die casting press except I would put an array of fans in front of the extruder
If you keep it at plastic stage it'll probably come out mostly solid, set up a simple motor to automatically wind it up and you'll get low quality ABS for probably the same cost as shipping it from China.
Also you'll probably have to manually separate stuff like glass, nylon, wire, acrylic, ect
Are these gateron? Or some other type
how are we supposed to know? link the keyboard
oh its a royal kludge
doesnt say in the listing so it could be anything
though dont hope for much
Ah thanks
What should I test my credit card on
A8 is okay but needs a bit of work to match the di3
Its the cheapest of the copys of eachother, that I can get.
Be careful with cheap, the power supply will be a fire hazard once you go below like 250usd
thats why you get a MOSFET chip
Won't help if the power supply itself can't handle the current
The cheaper you go the more likely you get one that can't
>2017
>not wanting to die
normie
Wanting to die is so 2016
BOW DOWN TO THE
BOW DOWN TO THE KING