Message from @Goz3rr
Discord ID: 387593727272550401
I disassembled the extruder to attach a pen to it to draw christmas cards
now when I put the filament in its stuck
To make matters worse the filament has completely snapped off so I have no chance of pulling it out now
Make sure your hot end is actually getting up to temp
we can pm each other if you want
I'm sure it is, I heated it up to 210c
and it melted my pen
If it is, heat to 240C and push though with small hex key
Hm, might need a full disassemble
Might be clog of pen plastic
Try pushing it through first though
i got my tevo tarantula clogged on the second print because i didn't push the bowden tube all the way in
heating up the hot end and manually shoving some filament in, letting it cool a little and pulling it all out at once worked
A8 is direct drive isn't it?
no idea
wouldn't it still have a small amount of tubing from the extruder to the nozzle
Also yeah cold pulls usually do the trick if you can do it
Not usually
The fancier ones sometimes do
my titan extruder came with a ~5cm piece of PTFE tubing, which i assumed would be used if you mounted it to the hotend directly
restarting the phone seems to have fixed the lineageos icon on the battery statistics page
I might just flash another meme ron
Dissapointing 11.11 haul
owo
It's the 0.01 carabiner multitool
nice julian
what are your thoughts on this item?
It's way smaller than I expected lmao
i gave you scale lmao
Wuts this for
good question
it doesn't cut
Its pretty sharp
Pencil sharpener?
that makes sense
I guess
foreskin remover
yeah ropecutter
Oh, rope. Yes, that makes more sense than what I read it as initially. 👍
rapecutter.. ye.. wwait