the definition of chinked

my battery life predictions for note 4x on lineage is fucked, yesterday evening it was 71% with 33 hours levy

now its 50% with 29 hours

maybe I need to roll back or clear dalvik

Mine was fucked when I used lineage too

in case anyone here has one http://en.miui.com/thread-1253826-1-1.html

although from what I understand, it's a complete pajeet phone

@bap what plastic were you using

PLA

And is there a nub of filament to grab with pliers

No

My filament is stuck in the hole below the extruder itself

Do you have a 1.5mm hex key

I disassembled the extruder to attach a pen to it to draw christmas cards

now when I put the filament in its stuck

To make matters worse the filament has completely snapped off so I have no chance of pulling it out now

Make sure your hot end is actually getting up to temp

we can pm each other if you want

I'm sure it is, I heated it up to 210c

and it melted my pen

If it is, heat to 240C and push though with small hex key

Hm, might need a full disassemble

Might be clog of pen plastic

Try pushing it through first though

i got my tevo tarantula clogged on the second print because i didn't push the bowden tube all the way in

heating up the hot end and manually shoving some filament in, letting it cool a little and pulling it all out at once worked

A8 is direct drive isn't it?

no idea

wouldn't it still have a small amount of tubing from the extruder to the nozzle

Also yeah cold pulls usually do the trick if you can do it

Not usually

The fancier ones sometimes do

my titan extruder came with a ~5cm piece of PTFE tubing, which i assumed would be used if you mounted it to the hotend directly

to make everything line up nicely

restarting the phone seems to have fixed the lineageos icon on the battery statistics page

I might just flash another meme ron

Dissapointing 11.11 haul

owo

It's the 0.01 carabiner multitool

nice julian

what are your thoughts on this item?