I concur with greg 100%

@Izat - VA keep an eye out for broken tabs on outlets. They may be switched

As a rule of thumb on a 120v circuit a 100w is around 1a

And dimmer switches can only handle usually around 600w. So if you plan on dimming that area you may need to divide the load across two dimming switches

Good to know, luckily no dimmers here but I may do some on the main level eventually

Anyone ever make an alternator?

That is, convert physical energy into electrical?

It is not the easiest thing to do. You basically have a motor that is working backwards. You have to have quite a bit of copper windings inside the frame and you would have to spein it very quickly. If you had it attached to a bicycle or other of means it would not be so bad

Electric lady would not be that difficult to build the difficult part is when you have to do the spinning!

*electrically

Seen them on sail boats. Was also thinking sewing table pedal.

Yes you have to get the ratios in the windings right and then have a set RPM to keep the voltage at a set level. I'm sure there are simple units I'm talking more along the lines of a consistent voltage output of 110v or higher

Any way to do it without copper? Practically I mean.

The two components of a motor or generator do not actually touch. It works off what is called induction. Copper or gold would give the best results. Some type of metal has to be used other metals do not work as well

Yeah is it basically a spinning core inside of coils?

Rotor and stator

Yes sir and giving what you're trying to do using steel or something of that nature just wouldn't work for the induction

Keep in mind when building this that it will always take more energy to make energy than the energy produced. Heat and friction are energy losses

^^^

This is the equation that prevents perpetual motion

Ugh im at a negro house giving an estimate

Literally a chimp out on tv..... and the smell....

slave art?

Hahaha

@Lebens What is a "R&R commercial 225A single phase panel?"

Remove and replace a 225A single phase panel

Ah ty

@Lebens so you basically disconnected all the wires from the old panel, tracked them, and required them to the new panel?

How long does that take?

Im on my 10th hour

Still not done

Tomorrow i have another one to do

Holy feck

Wednesday im installing a lighting control system

2.5 days work and ill clear $6k

Contractor life

That's awesome.

@Lebens that panel/meter combo in that last picture is the second one of those I've seen you post. It's similar to what I would call a meter bank for a multi dwelling bldg. Is that something that is common for your area. Is that what the utility requires? I'm in Louisville and all of the services that we install have a meter Base outside and then a panel beneath it or just inside the wall from it. I was just wondering if that is something that you personally prefer or is that something that is common to your neck of the woods

@Deleted User east coast vs west coast. Out here we use all in one enclosures, i hate it. You guys have the better version

@Deleted User this building wanted a way to work on the panel without shutting down the substation also. With the meter socket they can monitor usage and have a means of disconnect for swapping main breaker

I was getting ready to run an outlet off this existing outlet. First tree ground wasn't connected and three was a jumper you can see in the pic. It's this normal practice. I've never seen it before.