Message from @Mips
Discord ID: 486851372327895040
he reviews and even helps launch 3d printers into fabrication for companies
and obviously enthusiasts and beginners
yup, check out his channel
or if oldfag, use him as your consultant
he'll teach you what's what and what to look for
I believe the prusa mk3 is in high regard
Vs 3000
That's a steal
Nah
There are sucky ones for 150ish
Figured I wait a bit
Alot happens in the field atm
I touched cheap prints and not just yet imo
There are industrial machines for metals
But at like $30m I couldn't buy it
150ish and sand by hand
Commercial is down to 0,5mm extruders
Yup
0,5mm lines of plastic
@Deleted User last I checked they were above 3k
Wat
Not extruders
I'll go on the gargler when I get in
I'll be damned
0,01mm
but 3k
go steal copper boi
So Contrapoints does a video on incels
Gets 580,000 views
[*head discombobulates*]
150ish
Layer thickness: 0.1-0.4mm
you'd have to sand it down
but it's doable
Fuck I might actually get one
that's what I mean
his channel is legit
after going there I could buy one