Message from @Deleted User
Discord ID: 661018725037768724
Fabricating a faceplate for the new lathe. Cut from a slab of 1/2 in hot rolled steel it is turned to the proper diameter and drilled and tapped to accept clamping Hardware. This is used to clamp odd shaped parts in the lathe so they can be machined.
@Deleted User do you know who AvE is?
If not, then you will very much grow to appreciate his mad skillz and knowledge:
https://m.youtube.com/user/arduinoversusevil/featured
Links to his vijayos could go in nearly every channel on this server. Make sure you brush up on your AvE-speak.
@Karnivore yes I'm subbed to his channel, I refer to it when I need to break something
Deburr with file and Stone, ready to be mounted on the lathe spindle
<@658882725440258078> hello and welcome
Face plate mounted on the spindle
Welcome @P2iKK
Good Morning Everyone
Good morning... From hangover city. 😬😳😂
I'm so good looking, some woman just curbed her car getting a good look at me
That's the theory I'm going with anyway
i'd run with that and ask if she needs assistance
I think she was embarrassed because she zoomed right off haha
c977779fd74d60ac69e84cb07b56f483
Flat Earth Gang, my group is only 1 member away from 2500! Invite a friend or 2!!! Make it happen!!! CMON NOW ;)
https://www.facebook.com/groups/302557566578803/
Look what the UN is preparing for
https://careers.un.org/lbw/jobdetail.aspx?id=127453&Lang=en-US
@Deleted User that's it then, its over