Message from @Tervy
Discord ID: 382928418427371520
they are for manlets
kek
and i want something like Kamaz typhoon but turned into living compartment
politechnika wro?
the building looks familiar
nvm im retarded
You know milsurp vehicles are notoriously terrible, right?
yes i do
and cash and gas hogs
it is smarter to buy full-lengt sprinter
and diy it to perfection
but armor plates cost so much ;_;
If you have a forklift and a torch you can probably scrap the armour from a non functional armoured vehicle
nah cutting armor plates is even more PITA even with wate&sand jet
and torch would ruin the plates
Right, the temper
What about chinkshit steel plate?
hmm alibaba
If you live near a rail hub or a major port it would be possibel
i do
quite shitty price from BHW500
How thick are you getting it?
Layering thinner plates might be more economical
And easier to work with
if i were to do it i would need to test it with 7.62
sooo aprox 15mm tops
20mm for sure but weight...
54r?
Because I'm pretty sure 10mm of plate would take care of 99% of 7.62 x39 ammo
and most of of 8mm ones too
depends if you want to prevent warping%
thoo 7.62 iirc does penetrate 8mm of RHA armor plates
@300m
sooo~
or was it 7mm plates
cant remember
(those are for AP rounds*)
Steel body armour in the US is about 10mm with antispall coating (truck bed liner), I think
tho if i consider those plates would be between the outer and inner wallpanels the 7.62 would still penetrate reinforcement beams and just make the car "tincan with superball in it"
composites cost a shitton