i AM not a bowlcut man

<:thenk:329322130804047872>

it is a good printer

@Shrimpf

i'm adding dual extruders

which means replacing the whole effector and the electronics

and a bunch of other stuff in the process of making that all work

Feels like more work than using a singular extruder

it is, but it's useful

soluble supports, 2 color prints, TPU living-hinges on PETG parts, etc

Just sell your printer at a slight loss and buy a proper dual one then

i'm kinda regretting going for 2 instead of just getting a kraken at this point though since it's ending up more or less a complete overhaul anyway

if you have an inkjet

take that shit out back

i'd need a much more expensive board for it than ramps but eh

and smash it with a slegdehammer

https://community.amd.com/community/amd-corporate/blog/2018/03/20/initial-amd-technical-assessment-of-cts-labs-research

if anyone cares about those amd security issues

well I have R7/1700

if there are problems

<:sadmitu:331056421342806026>

but I do feel these jews are dirty liars

they gave 24 hours to patch it

then released their shit green screened video

https://e3d-online.com/the-kraken-fully-loaded @johnfrum what i should have done

https://e3d-online.com/chimera what i did

well, i put volcano hotends on it for the longer melt zone instead of these standard v6 hotends, but

Wasn't it like that you needed root access into the processor?

CHINKED

And that's like close to an impossibility at this point?

talking about travel

I'll be going to Japan in 2020 with my mother

Confirmed now

nice

Might have said here already

But it was her sending a message to me at late night and had only be able to confirm properly with her over text a few weeks later

Basically we'd be going over there to see some of our exchange friends

Blow nose -> loads of red chunks.

👍