Message from @Kaytee
Discord ID: 425761220520443914
@why am I 𝓐𝓛𝓘𝓥𝓔 they need to ship a physical reset button to patch up frosty relations
Man, suicide and murder cars are pretty cheap.
A couple hundred in detailing and youll have a mostly good car
wtf is this
ffs i may as well have just not even kept any of the wanhao parts
doesn't work
i have replaced everything but the rails, leadscrews, and frame upgrading this thing for dual extruders, just one after another "oh fuck this is kinda janky" "eeeh might wanna keep these consistent" "fuck, doesn't fit" etc
well, and the bed, but that's in line to be replaced too tbh
You were shilling that a coupel weeks ago
i AM not a bowlcut man
<:thenk:329322130804047872>
it is a good printer
i'm adding dual extruders
which means replacing the whole effector and the electronics
and a bunch of other stuff in the process of making that all work
Feels like more work than using a singular extruder
soluble supports, 2 color prints, TPU living-hinges on PETG parts, etc
Just sell your printer at a slight loss and buy a proper dual one then
i'm kinda regretting going for 2 instead of just getting a kraken at this point though since it's ending up more or less a complete overhaul anyway
if you have an inkjet
take that shit out back
i'd need a much more expensive board for it than ramps but eh
and smash it with a slegdehammer
if anyone cares about those amd security issues
well I have R7/1700
if there are problems
<:sadmitu:331056421342806026>
but I do feel these jews are dirty liars
they gave 24 hours to patch it
then released their shit green screened video
https://e3d-online.com/the-kraken-fully-loaded @johnfrum what i should have done
https://e3d-online.com/chimera what i did
well, i put volcano hotends on it for the longer melt zone instead of these standard v6 hotends, but
Wasn't it like that you needed root access into the processor?
CHINKED