The entire arch tensed up and it was agonizing

Maybe try to not eat salt bombs

How does that make a difference

Many cramps can be traced to sodium imbalance

@Krieger The Viking Plague Doctor Just the sockets, but good chink. Tekton

I feel the screwdrivers make up for it though.

I think this one had more to do with me trying to pick my mouse up from my table with my foot so I didn't have to sit up

Nice

Oh you managed to read it before my dumb ass deleted instead of edited it

I don't what a reloading turret plate is tho

Top part

Looks like an elaborate excuse to suck cock to me

I mean what

<:blobcute:323673992131117056>

The problem is I have a drill press that I can't measure runout on because I don't have a dial indicator.

Get a dial indicator

What's a dial indicator

Damn thing rattles like i have a small mammal stuck in the belt and when I run it

Not sure if its the belt or the bearings, knowing my luck its both

@Krieger The Viking Plague Doctor Measures how far forward/back the lever is pressed, to a few decimals

>standard

😊

Take the belt off and duct tape it to a drill

Check bearings

Like tape a cordless drill on to the gear that actually moves the drill press's chuck

?

You mean to this

Yeah

That would require a lot of ducttape

Oh, that makes way more sense

...i dont have a socket set

Just don't do what I just did and demo with a Gatorgrip and chew up the shaft by accidentally hitting the launch button

Thank you for your sacrifice

Yours doesn't look socket-able

But if it's under half an inch you can just chuck it up

If it's over, I dunno, dowel in chuck, short length of tubing to go over dowel and shaft, pipe clamps over both?

That might be both the jankiest and cheapest solution

Just make a dowel, you have a drill press and an internet connection to watch Matthias Wandel