yeah

i was thinking a pressurised air cylinder as the thing that pushes it

but then again

the bb needs to be completely sealed within the tube

I’d just use a handful and make it scatter.

nah

inaccurater

If you want a single BB charge, look at hunting pellets.

and dangerous

i know that sounds ironic

but i dont want to kill

and a shotgun bb airgun has a higher chance of accidenitaillly killing

I disagree. With more projectiles being pushed down the barrel, they’ll move slower even if padded by a patch. Plus they’ll scatter and give a greater chance of hitting.

yeah, i still want to go with a single shot

is that ok?

Sure. You could look at refrigerator tubing, but it won’t be perfectly straight

any links?

Do you have access to .22 cal BBs? Or just .177

https://www.rebelgunworks.com.au/collections/air-pellets

yes

https://dragonplate.com/DragonPlate-Carbon-Tube-8mm-OD-x-239ID-x-24?gclid=EAIaIQobChMInOjok4r95wIVEr3sCh2TjwnGEAQYASABEgKND_D_BwE

I bet this would work. .239 interior diameter would fit a .22BB or pellet just fine.

you sure?

Fairly. A bit of grease would help.

hm

hm

alright

i will trust you

and buy both

If quarter inch interior is .25 and the diameter of the projectile is .22, there should be .015 inch on either side.

now make that the projectile

Of COURSE it’s a .40

@Dais17 about that guide

Shouldn’t be difficult. Get a narrow nozzle for the compressor. See how it fits in the barrel pipe. If it’s too small, use an O ring or something else to close off the escaping air. Then load a projectile into the barrel. Fire at will.

dude

i dont know how to do the trigger mechnicasm

also dont want to blow up

You said you’re using an air compressor, right?

https://www.amazon.com/Industrial-Adjustable-Extention-Pneumatic-Compressor/dp/B07GJQJJMQ?ref_=Oct_CARAsinC_3753811_0&pf_rd_r=JN3BKCKJ37M4V2E1CZMT&pf_rd_p=8c604f60-98bd-57c1-b259-c5b2bd2dac1f&pf_rd_s=mobile-hybrid-6&pf_rd_t=30901&pf_rd_i=3753811&pf_rd_m=ATVPDKIKX0DER

Ye