Message from @Grovyle
Discord ID: 535913809529929751
so get it registered and sell it because mp40s are pieces of shit?
oh at a pawnshop
>get it registered
Hughes amendment says hello
Doesn't matter if it was manufactured before 86, if it wasn't registered back then you can't register it now
**Forgotten Weapons** Uploaded a new youtube video!
https://www.youtube.com/watch?v=MmxIwBie1pA
I was hoping for mass CA noncompliance
but the cucks went and started RAW-ing BB's
instead of just patriot or featureless
Need to clean some rust and maybe re-tie the rope
How much did it cost @Dess Dess DESS
@Grovyle $300
Got two cases of ammo, sling, gun case and cleaning tool included
Not bad as long as you can refurbish it properly
Oh wow nice
How much ammo total?
43 bullets
Oh so 2 boxes
Yup that's what I meant
Yeah I'll get a case of ammo eventually
What round is it chambered in
.30-30
Do you reload? 30-30 is pretty expensive
No I don't
But I have a friend that does so I might pay him to do it
Basically it would just cover the cost + a small bit
lol
Start reloading.
3030 is easy to do
Get an XL650 so you can grow into it a bit with 5 stages
Don't go for the cheapo hornady progressives
I think they're pretty shit.
I'm probably going to get into reloading when i buy a SAA repro, .45 LC isn't cheap
.45LC is easier
you can get by without even individually inspecting brass headspace on straight walled rimmed cartridges
(That are low pressure)
Higher pressure shit I would not want to just size, check length and pound rounds out on
Highly wouldn’t recommend a progressive for a beginner. Did it myself and regretted instantly.
What progressive did you use?