Message from @galesteppes
Discord ID: 508044764118253600
I don't know the ic, I guess it's like an attiny 85
I made a lot of low cost/wearable/very smol things
yes its ATTiny 85
yes its ATTiny 85
i also have some bare chips in SMD, DIPs on the way
I remember I made a watch, that showed the time, but the same two hands cold also show North and South, point towards a coordinate
And even follow another device
Like a spy watch
thats cool
And it was super super small
what should i make for a wearable?
Imagine fitting 2 stepper motors, GPS, compass, battery, GSM in a clock
Yeah I know they make smart watch
But I had actual clock hands to move dude
you had the hands on stepper motors?
Not this one, but the same kind
i know what clocks with hands look like
can i see the motors you used?
There were 2 stepper motors and the mechanism to have them have the same center
Yep
Google canon stepper motor
Cuuute
Bought from AliExpress
No
Orrible
They are so fragile
They are so fragile
I bought 30, before I managed to solder ONE, I broke 7
But yeah, iper smol
But yeah, iper smol
They have just like 7 positions or so
But a clock needs at least 60 right
So I wrote from scratch all the code to control the microstepping, following radial coordinates etc
wonder if i can get servos this small
what am i supposed to use to attach motors to their component securely when they just have the spinning pin?
screw through the side of a housing around it?
Just kill you self