yuh

gonna be a wild ride

do you publish any kind of page yet?

nah

not yet

once i finish building my CNC and get some demo units out i probably will

from ground-up?

yeah

other than the drivers and pads actually

fuck diy-ing that

that's pretty brave

tho i will be doing in house planars at one point

ive already built a planar driver before so its not hard

okay okay

yeah shite that's a lot of sgfags

yep

im australian so theyre always on at the same times as me

@HEKTIK

cant see shit

there's two closed vent there

see the sticker

another one on the nozzle side

oh yolu mean on the back of the driver

You can see the part of the cable which was pinched by the shell, the green one

one big, one smol, in between two soldered ends

Even iPhone 7 can't do macro shot

my old phone did close up really damn well

my note 4x sucks dick

but for like 100usd i dont really care

Use this shill video screencaps instead

you can see a smd

draw a line covering the gap on his right hand's finger

o i see it

kz be like more screw is better, even though it does nothing.

removing both seals it's like another iem

Like the IEM now responds to covering the grill

Like low-fi ish?