It's diffucult to find fakes that aren't garbage on Ali, though you can get _homages_ with or without silly names.

only gypsies and niggers care about looking rich

If it wasn't for the brand name being so visible and recognisable, most normies couldn't care less what wrist fedora you wear

Not neccesarily watches just in general @s3bbe

I have seen the future

Redmi 5

with USB-C and NFC

who needs nfc

print screen this

all stores and groceries have NFC payment here

>paying for stuff

just steal it lel

>not getting NEET bucks

who uses nfc on their phones

why not just use contactless on ur card

also let me guess

Redmi 5 - 2GB of RAM

actually thats generous

@CIA it's handy if you forget your card I guess

fair

Expect the unexpected.

#hype

do any comfier ve monk replaceabl ear foam pads exist

i can hardly wear these for an hour

https://youtu.be/UeN1tFs8GrY

This goy is pissed

actually i should probs just buy more earphones

Just got some more usb charging cables

These ones have lighting and micro usb adaptors

Charging looks good also

with e-packet, how long after I get a tracking number before i'm "allowed" to track it

?

So I ordered a pair of headphones through Gearbest
The tracking number they gave list all the steps till it got yo my city
Then it says I wasnt at my place so they didnt delivered but it says that an hour after the visit it was delivered

Didnt says to who its was delivered
Error or in fact I got robbed?

where them watches at

So I finally got around to tearing apart my aula si-2013 (fb-2012 with lower end switches) to see if I could figure out my issue with my X key. Solder was all good, but there was this black dust in the bottom of the tray that I cleaned out. I also went ahead and dusted out all the shit I could stuck between the board and (retention?) plate. Decided to plug it in and no issues so far. So I dunno what the deal was.

I did manage to find and fix the source of the sticky caps lock key switch I forgot to mention because I never use caps lock. They complete the circuit on the board with a couple wires around that particular switch, and seal it all down with what looks like hot glue. There was a big glob all around the base of the switch stem that appeared to be putting it under pressure. Peeled that bit back, and now there's no sticking. Was pleasantly surprised to find that the face plate is actually aluminum.

how do people have so many issues ordering shit from china?

those sneaky chinamen