Message from @5W
Discord ID: 626280064446889984
hearing damage will be fairly low long term
like you need to shoot w/o earpro for a decent while to properly fuck your ears
the like 3-5 shots in an average defensive shooting
not gonna do a ton
Yeah you’re not going to go dead from a defensive shooting
oh ok. Still, would be interesting.
yeah its interesting to think about sure
there are those meme maximco guns
but i think the volume requirements for a can to properly function would make it pretty impractical
https://silencerco.com/media/contentmanager/content/maxim9-gallery-desktop-5_2.jpg like, maybe this, but with chambers that continued back into the grip by going above and below the trigger guard. Vent the gasses out the bottom.
And make it 45, if that's easier.
the challenge is it cant all go backwards
And have fun carrying a brick
you need a decent area infront of the muzzle
also that
like people are big on the g43x as the hot new carry glock
imagine what that would need as far as a can
like just the increase in footprint for a cc gun is pretty impractical
I don’t think it’s super feasible for a carry gun
yeah until like cc railgun days probably not gonna have a hearing safe one
Suppressor technology is pretty decent now, and they’re super prolific so it’s not like no one would buy something like that if they made them, but there’s only so much that you can bend physics
Most of it would be. Could you put chambers in the slide too, and do a delayed recoil so the slide doesn't go back immediately? when it opens the chambers would vent but it would dissipate some energy first.
thats the trouble
Tbh the maxim 9 doesn't look that much bigger than a 34 with a x300.
vast majority of noise is from the muzzle @Red Korvo
Yeah but are you CCing that?
No, but I know some people have, so it can be done. Just uncomfortable.
It’s not something that I would really consider an EDC piece
Unless you’re rocking YNH levels of extra fabric
like in descending order of loud shit its supersonic crack, gas concussion around the muzzle and everything else is a distant third
I don't understand what you mean @franknotcreep. Are you saying the ports into the chambers have to be close to the end of the barrel, and porting it all the way back to the slide would be too far?
Ccw a B&T VP9.
porting all the way back would kill all your velocity
The ports would all still be in the barrel.
oh.
and youd have a garbage cc gun
because you bled all the energy out of it before the bullet leaves the muzzle
And you could use high temp plastic baffels at the back where the heat is lower to cut weight. you wouldn't want to mag dump with that of course.
hmmmmm
yeah the real trouble is sure you could get it super fucking quiet porting it all the way back
but if you do your fouling goes way up, and your bullet is gonna be weak as shit, and your gun wont cycle