I will, especially if they're unsupported. But I think the jigs all have a lot of support for the bits.

But the plastic being softer itll be easier to do also you dont have to worry about your bits walking

The punch prevents the bit walk

Sounds good.

Also dont forget to step up the holes if its not wantin to cut

I've used punches for that before, and I'll do it if I have problems, but the jigs SHOULD do plenty to keep them from walking. They provide at least 1cm of steel around the hole to guide the bits.

Step up?

Start with a smaller bit and step up the size until its the correct size

Ah, so pilot holes, gotcha.

Yee

Niggas scared to use the cone bit but the thing works if you pay attention

So I've blocked you. Wondering why? Please consult the criteria below:

✔You're a <@&559943777024737292>
✔You're a <@&558119990725705748>
✔You're <@&559951530955112458>
✔You're an "<@&600465023772524565>"
✔You're a <@&559943292029239296>
✔You have <@&558103330405220383>

Discord is my weapon of justice, and the block button is my bullet. Pow (not supporting or advocating gun rights in any way. Just a metaphor)

<:cryingcat:404139925466906654>

I don't mind cone bits but these jig and tool kits should be pretty solid. I don't mind improvising if necessary but I shouldn't need to.

You wont know till youve got everything infront of ya

I'll probably get one of these, most likely the drill press jig because it's so cheap and I can borrow a drill press. https://www.80percentarms.com/ar-15-lower-jigs/

Oh absolutely. I'm just not too worried because the good kits have had the shit tested out of them so every step is well understood by the manufacturer.

Im thinkin about gettin a storage unit with power n making it my workshop

If anyone knows a good source for 80% lowers, especially if they're mil spec, let me know. Bonus points if they have an "auto" position marked in minecraft.

Good morning @PunishedSmug how was your thanksgiving

Gud

The blind leading the blind down here at <@&558119990725705748> general.

Tfw only one that went stag to Thanksgiving

lol ok

@Festive Any idea how much harder 7075 will be to do this with than 6061? I've heard it's more time consuming, but that it machines better and is stronger (not that that makes a huge difference).

Idk the diff between the steels

But harder steel = harder to mill

Those are aluminum,

Well fuck idk at all then

Retard nigga hours down here with the blue man group

Better dead than red @Rob

I like opening this chat and seeing all blue and immediately realizing that none of the messages for the past hour are worth reading, at all

So I've blocked you. Wondering why? Please consult the criteria below:

✔You're a <@&559943777024737292>
✔You're a <@&558119990725705748>
✔You're <@&559951530955112458>
✔You're an "<@&600465023772524565>"
✔You're a <@&559943292029239296>
✔You have <@&558103330405220383>

Discord is my weapon of justice, and the block button is my bullet. Pow (not supporting or advocating gun rights in any way. Just a metaphor)

<:cryingcat1:566058827716362280>

:cryingcat1:

Pls no bulli

Good try, <@&558119990725705748>

Well deserved ni**er, good job @MacPhysicallyRemoveCommunists !

I feel bulli

good

<@&558119990725705748> rise up 💪 💪 😤 😤 👏