oh nice

honestly laser weapon would have to be cannons just to produce deadly beams

cause you would need a lot of power

Bolters send that message home better though

Agreed

It shoots holy energy 😆

Poor IG troopers with their lasguns

Lasguns arent that bad

They're also basically the AK of the Future

No in mass there good

well... that but thats basically the only way to go about fighting the enemy anyway

Honestly AKs would probably be more effective

Need some sort of particle attachment for Lasgun for abit of kinetic energy

kinda? not really considering Stubbers look like they're basically just 50 cal or something like that

What about what? I don't have a .50 if that's what you were asking. :(

that reminds me

i found a warhammer Uzi

Today was a great day at the range

I picked up alot of brass for reloading

I was asking if your going to shoot (going to range) during Turkey Day [Thanksgiving]

I wondered where all my brass went...you Brass Gremlin 🤣 @Lucario what did you have fun with?

Just several different 22lr rifles didn't feel like getting the big stuff out

I almost reeled a 5 gallon bucket up with brass today

I can understand that some times you just want to plink the steel with a soft shooter

That’s a lot of bullets

He reloads so its worth it

That reminds me, I’m actually running a little low on my 22 ammo.

Lucario you got a suppressor for ur .22s

I'm good I've been stockpiling

You don’t really need those for .22s

I haven’t made it to the gun store to buy ammo because the gun store is always packed.

Strange reason but ok

I'll probably have a 5gal can filled w brass coming up during Thanksgiving....I've got a friend that reloads..I give him brass and I get 1/2 off ammo from him

Any advise on how I can get this reproduction M1 Carbine Sling through a Ruger 10/22 M1 Carbine front sling point? I can’t get it to swing out other wise I could get it through in a jiffy and I would be asking a stupid question. Thanks to anyone if they have advise.

Is that a screw that is holding the front sling point?

Yes. Can’t tell what size. Maybe 3mm Allen. 4mm is too big and 1/8in is too small.

Have you tried WD40 to see if you can get it to move?

Not enough

If you can get it to move some, have you tried to see if you can get a shim under it and slowly try and put more under it to get it up?

May need to rinse and repeat with the WD-40 while doing that and letting the WD-40 sit.