Message from @HEKTIK
Discord ID: 250097593592446976
Ausfag
Muh bootstraps
something something white people
just go to the GOP website and read up
The idea behind it is ok but the execution is terrible
Q&As are always kinda cringey
just do another vid
the original execution was kinda bad and didn't take into account that the insurance companies would very quickly pivot to try to make even more money by using excuses that can't be enforced by the government
they rolled people up into insurable classes creating a self-fulfilling prophecy that people in the obamacare class are expensive to insure
anyway this is /pol/ shit gtfoo
all I know is that this place was filled with pretty noisy children before
and zambz was a funny not-sure-if-trolling maga-hat enthusiast
i lulzed when I realized he was a kid
and then I started wondering if I should gtfo back to IRC since maybe all yous ppl were kids
zambz was unfunny and deserved a quick painless death xXD 🔫
Whatever happened to that one reviewer who had the fucked up leg
he becoming an robot
fucken sitting here infron of an industrial fan wearing nothing but boxers and im still hot
and probably going deaf
someone gimme some chinkshit to distract me from the eternal agony
so I have an old 15 year old pair of these https://www.amazon.com/Sony-MDR-V700DJ-Studio-Monitor-Headphones/dp/B00005QBU6 and the plastic is slightly cracked near the swivels (it's a common design issue); anyone have repair tips
im only HALF convict
epoxy
or just buy some cheap headphone like HD 681's and attatch the cups to the 681 frame/headband
if its like truly fukt
nah they're still wearable
just fragile / on the verge
wtf?
I'd like to keep them intact b/c nostalgia reasons
just epoxy it or contact cement it
did jap moot break 4chan again
huh
looks fine to me
super slow image and post times
fugg <:benis:239668961011040257>
works fine for me
must have been just a hiccup
is there a /csg/ on the other chans
bytemask, don't use acetone or solvent based cements because lmaoplastic. If you can get them apart into bits, your best option would be to epoxy both sides, inside and outside, then sand to fit once cured
i've been getting extremely slow image load times for the past several days, i don't think it's a hiccup