@.PunishedShlomo i havent messed with it. from what i understand its just a custom build of ubuntu - not designed specifically for mining

I went on an overclocking run and I got a pretty good balance between temps, but it had crashed so I went back by 4mhz on the core and 8 on the memory.

what was your memory at?

over stock

im still waiting for jewgle to release quantum core processors and that architecture. itll be hard af to even get ahold of one but im ready to buy.

@SchloppyDoggo

quantum CPU's require extreme cooling

well, stock speeds are 1366 on the core, 3505 on the memory, I got the core to 1450, got the memory to 3628

not because fo power draw/heat it's because they can't function properly without it

980 at 1450 is pretty high

I know, I was surprised

dropped off after 1460

but honestly, lowering that to 1425MHz for the stability exchange wont hurt at all

gonna stress test it all of tomorrow and see

not even 2% difference

for huge stability benefit

yeahhhhhh

so you're wasting time lol

I might :^)

just do 1425 core and 3600 mem and be done with it

1425 is already like

over 17% reference stock clock

not factory clock

for non-reference

I got 6384 on FSE, which is pretty good for a 980

GTX 980 Engine Specs:
2048
CUDA Cores


1126
Base Clock (MHz)


1216
Boost Clock (MHz)

the card came at 1366 boost

and it ran nice and cool

1270 base

relative to stock card boost you, get just over 17% higher freq with 1425mhz

just leave it there and be done with it

and 3600 on mem

I will, just gotta figure out what voltage it's happy at

you're manually changing voltage for your GPU?

yeah, Precision XOC

If you're going over highest auto-voltage, then you are degrading the card faster, it will barely do shit, but also voids warranty

what's the max voltage increase it allows?

don't do more than like 8% more than max auto volatge

and find a stable spot there

I did like 50mV over lmao

I don't care, gonna run this baby into the ground