*dab*

Can't wait for stubbs to take over this channel lmao

If I tape spear to gun am I gunsmith

Channel Rules:
1.) No discussion of doing illegal shit. I will immediately ban you for it.

2.) Saying "in Minecraft" after discussing doing illegal shit will not keep you from getting banned, nor will it stop feds fron knocking on your door, you absolute fucking retards.

3.) Don't try and sell guns here. Guns being defined as fully assembled firearms and completed receivers.

4.) This is not a shitposting channel. This is a channel meant for helpful discussion as well as exchanging information pertaining to gunsmithing.

Ok so serious discussion time: who has user data on the new .300 PRC, it is looking like a contender for the win mag throne but my in depth ballistic knowledge is lackin

When did it come out? I haven't heard of it yet

They put it put a few weeks ago

Before the new factory

I'm a shameless hornady fag and also rcbs

Oh I like hornady fine, problem is stuff like that only catches on if the manufacturers start putting out rifles at accessible prices, otherwise it goes the way of 6mm creedmoor or any of the countless AR platform 5.56 replacements that arnt 300 aac (or 6.8 to an extent) and becomes harder to find, and higher priced

I mean look at 6.5 creed

.300blk

Most calibers that aren't in military service drop off after a while

Although there has been some new interest in a 6.8 rifle which I'm not opposed to

6.5 and 300 look like they are doing fine for what they are from what I see, I haven't seen heads or tails of .224 valk all year though

What does seating a projectile more shallowly in the Cartridge do anyway?

More powder

.224 valk is starting to show up more

I thought it was an accuracy thing

I've not even had anyone ask if we have it so idk

I mean if you move a projectile up even 5 thou it does affect your accuracy

Most guns have the bullet 15 thou from the lands of the barrel and the closer you get to the lands the more accurate, but then you run into heat issues when it gets super hot

Your stock factory 700 will have it 15 thou

Just because the projectile starts out seated in the rifling?

Or atleast closer to it

My IRL bro thinks the forward assist is a good thing

How do I tell him he’s stupid@

not stupid just old

a forward assist is like retard proofing a rifle

I mean is there a problem the forward assist solves

If your round doesn’t chamber right the last thing you should do is hit it really hard

Anyone who thinks a forward assist is necessary is either old or a marine

Minecraft gun 😎

Epic

Man this channel is gonna be a shit show in no time

What tool is used to cut rifling? And what do I need to use one?

a lathe i imagine

A big ass lathe

You'll need a broach