Message from @HEKTIK
Discord ID: 406269257337405441
just follow the default gainclone design and its piss easy
you can also get chinese kits, which are fine
though the PSU's on them are apparently a bit sketch
It's not? Damn that's the impression i got from all that stuff :/
its just an amp chip
gainclone is super simple
ignoring transformer/chassis/heatsinks/wire, its like a $30 amp in componentry and pcb
🤔
or just buy a normal amp 😂
yeah feel free to go buy a chinese overspec'd TDA amp that runs at 10 times higher than spec gain
and then have to redo the gain stage
how else do i power my monks
straight from the wall
so thats why the ground plugs are round
ya
ZZZSZzZap
As i wanna build one that powers 4boxes, no sub, would you suggest i buy everything from scratch,
or, to get back on my first point, can i just buy a chinese prebuild, modify a tad and be done with it..
@Windatica It's just to listen to some music while cooking, don't need to go full audiophile there
if you can find a decent TDA/Tripath from china that actually has verified measurements that dont roll off in retarded places, and operate to chip spec, thats fine
but otherwise its easier to build from "scratch"
or just at medium volumes
Eeh
They're 70/100W
lol
thats probably peak rating, which means fuck all
youre not unloading 100W into a speaker unless its some stupid maggie or some other rediculous shit
Yeah
I didn't really thought of it so far
Maybe i should test them first on like 30/50 and see how they sounds
my reasonably large monitors run off my beta 22 fine which only puts out 18W
Sounds good
*heh*
Thanks for all the advice.
Sorry, i really never touched audio before. It's all a bit new for me.
all good
just glue a bluetooth speaker to the wall, or better yet, get one of those shower ones so you don't even need to glue it
<:alismirk:230784726615588865>
my $10 bluetooth speaker measures flatter than a ton of like $20k+ speakers lol
I imagine now a speaker dropping into my soup or some shit
lol
stop cooking right under your music