hold on actually it might be my solder
probably not
err this sounds complicate, when i solder my new jack onto my xiaomi piston 2.0 what do i have to look out for?
shorts
other than that its ez
just have some heatshrink on hand
shorts?
as in you short left and right at the solder joint
you mean cutting it right
and make sure to test which is left and right obviously
what am i gonna use heatshrink for
if that shit isnt the right length its hell
ahh this sounds complicated man
nah
its not complicated but its super easy to fuck up
Ok ill watch a YT vido before i do it
should be alright
like if you skip simple steps they bite back
its just solder on 3/4 tabs and and screw on the rest of the plug
just have a list you go through
^
its braided cable, will that be a bitctch to strip the wire?
itll have rubber underneath
i got a shitty chink wire stripper too\
ok co
COO
cut through the braid with a knife or something
i'd just replace the whole cable but it depends on what type of iem you have
look forward to the revival of my pistons
most of the time that's not an option
pistons arent removable
replace whole cable sounds complicate
you could do a mmcx or two pin mod i guess
i mean physically replacing the cable
but it'd be way more complicated
that's how much i hate the enamel crap
lol
that's what i did on my takstars
which tkastars u got?!?!
i want to know
