Message from @Kimichiboi
Discord ID: 471106357739913216
Weighs 176lbs and I've charged it once
I haven't been able to run a test that I would consider accurate on it
Lmao
Thats legit
Tfw too brainlet to diy electronics
I told the manufacturer specs and gave them my card number and said just ship it for free
I didn't think it would weigh so much
Whatd u advice for a 12v 3A diy battery
I used 3x 18650 but they cant really deliver that capacity
Need it to power an actuator
I usually get 13A at 12 constant safely off a set of 3 18650's
Really, then the actuator is being a piece of shit and not actually drawing it
Good to know
You could always try adding another set in parallel and verify it
Hmmz
It would be your wires can't deliver?
Good one 👌
What gauge?
Ohh that might be it
22 i believe
I use 16
I'm literally Chinese
<:chink:323022148870602752>
I accidentally blinded my dog with the flash
I toyed with led lights
Then soldered my own led lights
Then more shit like that
Bit of reading too and some physics in uni and high-school
I was only allowed to use what I made for school
I made a calculator
Repair my own headphones stuff like that
just feel really dumb when I see other people make diy stuff smh
And 3d printers require some electrical knowledge
I built a 3D printer
This one's just el tape tho
Ah thought i didnt have this pic nvm
But these are operated with an actuator on the back
I think i just need to shell out more money for a decent actuator