Message from @Sasquatch GSF III%
Discord ID: 829856949394341908
Suck pelosis dick that's expensive
I'm doing fuel filters and left side ball joints on it next week
Yeah, gotta replace the high and low pressure pumps, all injectors which means all injector lines, and most of the fuel lines as well as drain the clean the whole fuel tank.
Fuckarubermonkey
It’s not fun.
The only thing that is worse is resealing the upper oil pan.
36hr job
Valley pan
They also don’t use normal gaskets on them just black silicone
That blows
It sure does. If your turbo goes out either go aftermarket or get a 2017+ turbo.
Roger that
Sure sounds like Ford diesel is not the way to go 😂
Cummins all the way
Until you drop a tranny
Then slap the Allison in that bitch
That’s the best setup. Unless you go NV5600 with an upgraded 6th gear nut
Chevys are nice until you want to haul anything or use 4wd
Or until your front end drops out 😂
That too 😂
I haven’t seen that one yet personally
Don’t worry tho I blew apart my 1 piece aluminum driveshaft last night in my Chevy
I’m just talking shit cuz I got a Ford gasser lol
Lmao same I have a Chevy gasser
Blew apart my driveshaft so I did the logical thing and bought new wheels so I don’t have to run my 37 all the time and tear up my drivetrain.
Sucks about your drive shaft, I had to rebuild my tranny about 3 months ago
My original tranny was rebuilt 7 times...
Same shop kept messing it up.
Shittt, so far mines been good! My front pump bushings were worn so it was causing the front pump to push forward making a leak.
That sucks. I’m getting ready to rebuild my engine and throw a hog ass cam in it.
Gonna be fucking chomping!!
I want my cam to hit harder than a drunk step dad.
I love the sound of cams
Same, I’m looking at a stage 3 cam from texas speed then either getting a 4l80 with a trans brake or getting a NV4500
Might mess around a put a solid axle under it too who knows.
Fuck it might as wel
Yessir. Ol Dana 44 under the front with some 5.13 gears and throw a gear set in the rear to make it a 5.13 and some 8” lift springs so I can clear 40s
Sounds like a good SHTF truck
8” spring I’ll give me about 10” over stock
That’s the plan, I want to get a giant front bumper and have this truck set up to boogie in a hurry it something happens.