High pressure fuel pump and then it goes out it fills the whole fuel system with metal shavings. 10k fix at a shop. The pump alone is $1600

It used to work at a Ford deal in the diesel shop.

Suck pelosis dick that's expensive

I'm doing fuel filters and left side ball joints on it next week

Yeah, gotta replace the high and low pressure pumps, all injectors which means all injector lines, and most of the fuel lines as well as drain the clean the whole fuel tank.

Fuckarubermonkey

It’s not fun.

The only thing that is worse is resealing the upper oil pan.

36hr job

Valley pan

They also don’t use normal gaskets on them just black silicone

That blows

It sure does. If your turbo goes out either go aftermarket or get a 2017+ turbo.

Roger that

Sure sounds like Ford diesel is not the way to go 😂

Cummins all the way

Until you drop a tranny

Then slap the Allison in that bitch

That’s the best setup. Unless you go NV5600 with an upgraded 6th gear nut

Chevys are nice until you want to haul anything or use 4wd

Or until your front end drops out 😂

That too 😂

Or all their electrical issues causes a fire 😂

I haven’t seen that one yet personally

Don’t worry tho I blew apart my 1 piece aluminum driveshaft last night in my Chevy

I’m just talking shit cuz I got a Ford gasser lol

Lmao same I have a Chevy gasser

Blew apart my driveshaft so I did the logical thing and bought new wheels so I don’t have to run my 37 all the time and tear up my drivetrain.

Sucks about your drive shaft, I had to rebuild my tranny about 3 months ago

My original tranny was rebuilt 7 times...

Same shop kept messing it up.

Shittt, so far mines been good! My front pump bushings were worn so it was causing the front pump to push forward making a leak.

That sucks. I’m getting ready to rebuild my engine and throw a hog ass cam in it.

Gonna be fucking chomping!!

I want my cam to hit harder than a drunk step dad.

I love the sound of cams

Same, I’m looking at a stage 3 cam from texas speed then either getting a 4l80 with a trans brake or getting a NV4500

Might mess around a put a solid axle under it too who knows.

Fuck it might as wel

Yessir. Ol Dana 44 under the front with some 5.13 gears and throw a gear set in the rear to make it a 5.13 and some 8” lift springs so I can clear 40s

Sounds like a good SHTF truck