Message from @Tanner - SC
Discord ID: 410612312777555969
Model 130202-3205-01
Pull spark plug with wire still attached, pull starter, see if spark is made.
Tested with voltimiter - has juice
also zap test
But does it go ZAP
aye
Fuel tank plugged with debris?
Cleaned it, dried it
🤔
Does it flow into the carb?
Seems to. Have to take rubber seal off to check but it's wet in there
Also, “won’t turn over”, you mean “won’t fire”?
aye
You could run the primer button 50 times with the spark plug removed and look to see if gasoline is in the cylinder.
no primer button on that model
Pull start?
aye
but that's a good point
i havent looked into the cylinder while pulling
Gas sitting for a while makes me thing somewhere between tank and cylinder the flow is plugged.
me too but I took the carb off the tank and cleaned the line (which is just a straw)
Need to verify fuel in cylinder
And the exit of the tank could be clogged
Could have an in-tank fuel filter
kk will report back on that. 9/10 small engine issues ive ever had are fuel flow problems
it does
I took it out
Could still be plugged
At the tank exit maybe
Lack of primer is stupid
old
Old shit had primers
There's pic of fuel straw (34 I think)
Lemme check cylinder for fuel and i'll report back tomorrw
When did it last run?
Is it a 2-stoke?
4
See, I knew it wasn’t old. Old stuff was 2 stroke and had a primer.
Did you change the oil and filter?
aye
When you pull, is the resistance normal? Do you feel the compression pulses? Does the exhaust go “blop blop blop”?