Message from Deleted User in MacGuyver - Skills & Academics #electrician
^i did that twice already replacing all the outlets; I have a pretty healthy fear of getting zapped
Thanks again for your input, it's much appreciated 👌🏻
Yes I can be difficult because you have to kind of visualize how the circuit works a lot of times in order to work and safely. Anytime someone with limited experiences working on something they should be energized the circuit
I concur with greg 100%
@Izat - VA keep an eye out for broken tabs on outlets. They may be switched
As a rule of thumb on a 120v circuit a 100w is around 1a
And dimmer switches can only handle usually around 600w. So if you plan on dimming that area you may need to divide the load across two dimming switches
Good to know, luckily no dimmers here but I may do some on the main level eventually
Anyone ever make an alternator?
That is, convert physical energy into electrical?
It is not the easiest thing to do. You basically have a motor that is working backwards. You have to have quite a bit of copper windings inside the frame and you would have to spein it very quickly. If you had it attached to a bicycle or other of means it would not be so bad
Electric lady would not be that difficult to build the difficult part is when you have to do the spinning!
Seen them on sail boats. Was also thinking sewing table pedal.
Yes you have to get the ratios in the windings right and then have a set RPM to keep the voltage at a set level. I'm sure there are simple units I'm talking more along the lines of a consistent voltage output of 110v or higher
Any way to do it without copper? Practically I mean.
The two components of a motor or generator do not actually touch. It works off what is called induction. Copper or gold would give the best results. Some type of metal has to be used other metals do not work as well
Yeah is it basically a spinning core inside of coils?
Rotor and stator
Yes sir and giving what you're trying to do using steel or something of that nature just wouldn't work for the induction
Keep in mind when building this that it will always take more energy to make energy than the energy produced. Heat and friction are energy losses
This is the equation that prevents perpetual motion
Ugh im at a negro house giving an estimate
Literally a chimp out on tv..... and the smell....
Remove and replace a 225A single phase panel
@Lebens so you basically disconnected all the wires from the old panel, tracked them, and required them to the new panel?
How long does that take?
Im on my 10th hour
Still not done
Tomorrow i have another one to do
Wednesday im installing a lighting control system
2.5 days work and ill clear $6k