You've gotta push the boat out man

>"shimapan" striped grocery bag

>gf

i had one of those

Thanks /int/

Not sure how I managed tbqh

what the fuck

>tfw no gf

Buy a stinky chinky one??

no thx

did you finish the welcome video @Phatique?

@Deleted User you're getting the uv-5r?

FUCK I FORGOT

been on a this is england marathon today

I might slib, trying to get the scanner working

so not the top of the line one?

is the scanner busted?

I think I'm doing something wrong

I have it scanning, it stops on channels but all I hear is static

volume dial is way below 11

move it outside?

could it be related to signal?

all the signals I see online have a TX and RX frequency

there's nothing I can see in here to make this do that

but maybe I'm missing something

I programmed in to scan between 445mhz and 460mhz

this is england 88 ep 1 was fucking shit

does it get better?

it stops on distortion

but I can't make much out

look up a pdf of the manual

I am, hold on

http://support.radioshack.com/support_electronics/doc45/45532.htm

this is what I'm following

LIMIT SEARCH

The limit search procedure allows you to search within a range of
frequencies. You can store up to ten limit search ranges in the search
banks.

1. Press [PROGRAM], and the search bank number in which you wish to store
the limit search range. Press [0] for bank number 10.

2. Press [LIMIT]. "L" and the search bank number appears in the display.

3. Enter the lower limit of the frequency range. Then, press [ENTER].

4. Press [LIMIT]. "L" changes to "H" in the display.

5. Enter the upper limit of the frequency range. Then, press [ENTER].

6. Repeat steps 1-5 to store the limit search range into the search
banks. You can store up to 10 limit-search ranges.

7. To recall a limit-search range, press the appropriate bank number.

8. Press [UP-ARROW] to search from upward starting from the lower
limit. Or, press [DOWN-ARROW] to search from the upper limit to the
lower limit.

9. When the scanner stops on a transmission, press [MONITOR] to store the
frequency in the current monitor memory. The memory number flashing on
the display indicates the current monitor memory.

10. Press [UP-ARROW] or [DOWN-ARROW] to continue the search.

I did this

so the low and high frequency

press every single fuckin button

^

@zero do you know anything about these?