technology
Discord ID: 527849695020580866
11,181 total messages. Viewing 250 per page.
Prev |
Page 6/45
| Next
Venue probly if its gaytrail
Can power-vol down make it into flash ?
I've put it between two books so that the power button gets constant pressure so that it turns on the screen to show the battery warning every few seconds
I'll go for deep discharge
No I tried everything like that
It does go into flash but I don't see the screen and it doesn't take any input
If I plug it into the computer via USB, I can't write to the device either
The owner fiddled with the bios to install Linux and now it's ded
Aww shuck
Aint dells configed to autoupdate from usb stick ?
I mean throw new fimware at it
It shouls auto-process it as far as i know
And ofc in process reset bios
I believe dell has their own image for just bios resetting tablets
Due that
So if youbare lucky and that tablet supports fw update/reset vbios tool
Interesting, let me check that
But, I think he disabled the USB controller, too
Because nothing else boots
Probly under some name like "bios recovery 6264819"
Bios should still check for update even tho its "disabled"
As its part of self-check
And self preservation code incase idiots like ex user of that tablet
That repair technicians have some chance
I managed to get it down to 4%
Let's see if deep discharge is the key for now
I can still try that one later
It's losing about 1%/hour
hw do u check the batt
Rip battery
Lipo terrorist cell
i doubt it's going to work because there's probably a cmos battery in there
โ
I doubt there is one, it's way too thin to fit a button cell + Mainboard + screen
@whodun1t when the battery is below 5%, the screen turns on and shows "Low batter N %" for a few seconds
All it need is small corner somewhere
This seems to happen before loading BIOS
i've seen coincells thinner than a die+substrate
that are just soldered straight to the board
How long would such cell even last?
few years probably
a quick google puts it at 10% in 5 years
self discharge
as long as the board has power it shouldn't be drawing any power from the battery
I mean cr927 can hold bios for yeat if not more if properly implemented
if you can work out the device type you can just rip it open and disconnect the battery
and not bother with this discharge shit
yeah like i said, take the screen off
you probably need a heat gun
look up screen replacement tutorials
out of the dell tabs the smaller ones (venue8pro) doesn't have a BIOS battery but the larger ones (venue11/pro) does
might not even to
depending on the unit
actually since it's dell
can you tell me the service tag?
This reminds mw from story of <certain large hardware manufacturer who definetly does not make weapons too> used bake in pcb coin cells to keep system settings no matter what
Was bicht to reverse engineer
are you sure it's a single frame case, because all videos I find on the internet just pop the rear cover off
Can anyone recommend me a portable dac capable of driving 300 ohm speakers? Got hd600's and /hpg/ is useless
>/hpg/ is useless
When was it ever useful
Just like /mkg/
@totally not Cthulhu ๐ throw a budget for that
before someone drops professional gear
@Tervy for a portable dac? Under 300 would be preferred. Only ones I find aren't in range or not in stock
powerbank + something like schiits Fulla ?
150 usd total if you can find the fulla anywhere
afaik fulla drives itself from usb ?
it would be "portable" but bulky as fuck
makes me wonder if your casual Fiio could drive those cans
Yeah there was a fiio. The e12 Mont Blanc.
A5 can drive up to 300 but I thought you'd want it to be a little higher than the head phone
if tis marked 300 it most likely will be some bit under it
just so 300ohm drivers can drive it as its marked 300
at least most electronics are built like that
dunno accurately incase of dacs/headphones
Creative Sound Blaster E5- yay or nay @Tervy
@totally not Cthulhu ๐ 300 ohm speakers?
oh
you mean headphones
lol
i mean
how loud do you want to go
i could drive hd 600 fine from my phonbe
id say listen to bentech
hes smart
@totally not Cthulhu ๐ e5 looks ok lllol
or look at the fiio stuff
really anything should work
what do you mean by portable dac though?
like phone usage?
if so you need to be careful
speaking of bentechs knowledge
nitecore LR12 ? any better twistys ?
It's not loud that I'm really looking for. I have an iPod for music and if I plug in a 100 dollar headset or the Sennheiser's, they sound they same. I just assume having a headphone amp would improve the hd600s to where they don't compare to a gaymers headset
@totally not Cthulhu ๐ eh I wouldn't expect it to sound that much better
Reee.
Thought these were supposed to be great or do I have plebian ears?
they are good
just througuly underwhelming
lol
give it a week or two
if you mostly just listen wtih a ipod, just buy a fiio DAP or something if you want a sound upgrade
that and oyu can use it as a dac as well lol
why do you want a twisty light anyway?
to car bag
-(not for me)
tow truck driver bro
oh do u just mean like a general lantern light
i'd just go for any 18650 flashlight and get a diffuser for it lol
maybe a light with a magnet is useful so you can stick it to the hood
or somethin
nah that twisty mechanic is optimal for messaging too so i might get one to myself troo
separate diffusers just to tend to be PITA
ye
ye i cant rthink nf anytihng like it
separate diffusers are just always lost when you suddently need em
ye
just this morning i could have had some use for one when i was helping people out who were stuck in snow
lr12 is 38$ on banggood if you don't mind waiting lol
does not sound that bad (and like i care about waiting :P
ye nothing like it lol
im kinda tempted tbh
makes even better EDC light tbh than many other
considering enough power (1000LM) single 18650 and diffuser always with you
yeah
and apparently non-pwm too
so no problem with messaging due persistence of vision fucks up movement on many pwm lights
all it really is missing is SOS function with that beacon
eww pwm
What's wrong with pulse width?
I work with it all the time.
"pwm flicker"
and thjje hum
i dont mind it on budget flashlights but past 20$ no
gotta admit i really want the nitecore tm10k
just for the relaly cute
10000 lumens!!
and it looks like silly cannon
to strap on your mech as launcher
other than (usualy low control rate on pwm setups and headache caused by it) there is nothing "bad" on it
Oh you guys mean for lights. I use it in alot of Controls
yeah pretty much
yeah for lights
ofc for motors its normal shit
BIG
WIDE
WITCHES
They use sound waves to map the finger print apparently
So finally in-built fingerprint reader
I'm cautiously optimistic
>sudo apt install akregator
>5 lbs of libraries and shitty PIM dependencies
i don't think so, KDEJEWS
the day I install akonadi is the day I get on HRT
@Krieger The Viking Plague Doctor how much will it be at launch?
i can't imagine justifying paying the samsung flagship premium
Not sure. It's samsung throwing in a bunch of weird shit so I'd wager at least (aussie dollars) 1400
I'm very surprised they fit 6 sensors and cameras from the front into that tiny hole
Well 5 sensors plus a camera
am i only one who actualy wants bezels on their phone
does it have the IR blaster on it so I can turn off the BIG GAME at the bar and get my asshole bulliied by chad and tyrone?
Talking about the front IR camera?
>ir blaster >current gen phones
infrared
ahahhaha
Yeah it's built into the same pinhole as the camera
i could never think of a utility for the IR blaster besides being a cunt at bars
What I'm annoyed about is they shaved so much bezel off the top but they seem really incapable of doing it to the bottom
controlling your whole IT-ecosystem ?
i mean i can ir-blast all my monitors,tv,desktop pc(adapter or monitor link)
any IoT shit can be tuned to listen IR(pretty much)
also some cars used to have IR-receiver for stuff
does microcontroller shit ship with an adapter or do you buy it seperately?
these days bluetooth is mostly replaced it tho its just not that secure due LoS brings additional layer of protection for IR
tho these days https://www.aliexpress.com/item/New-Arrival-Universal-IR-Infrared-Remote-Control-TV-STB-DVD-Household-Appliances-For-Phones-Drop-Ship/32905601317.html? just getting these instead of supporting phone is better option anyway (or similar products)
Let's be honest guys
yeah. idk I never got into IoT. the work/reward ratio of making my doorbell text me seemed not so worth it
We're not interesting at all for hackers to target us through IR
considering some people have 4-6 different remotes for their hometheatre
and proper IR-blaster+phone can take over all of that
@Stims indeed thats not worth it ? but automaticly slowly ramping up your light when you stop your phones alarm ?
you need physical access to 'hack' IR
or killing your lights when you leave your house
Why not just remember to turn off the light switch?
making sure that door is shut/oven is not on when you think "did i lock the door"
iot should be for all that usefull shit instead of "we message you with ~~advertisement~~ your shitty shit from fridge just due you bought our frige model"
it does not even need app tho
simple website to show your statistics/remote stuff is easily done with just esp-32~
but yeah some people see the use of IoT and some people see the use for "smart features prebuild"
if i had more time i bet my lights would be more automated in this apartment
binding alarm clock to roof ligth , kill all lights when im out of the apartment, that darn remote checking for front foor/oven
ofc proper info dashboard website (probly something like heimdall on steroids
>hold on, I have to ssh into my apartment
idk I don't really mind turning lights on/off
not even ssh just login via your htaccess and you can do all on website really
i can't justify not doing that kind of stuff. maybe i'm just lazy/stupid
electronics and stuff is hobby/work for many who dip in them
rest use those "smart devices"
My face recognition camera has an ir blaster next to it
Could it be used to operate tv's and such?
if you can get access to that ir-led with app
sure
"universal remote" apps
Don't think I can
anymote is probly the first things id test
Not sure if its a setting I am missing
hell you could control your air conditioner and DSLRs with same thing
but yeah ir-led sadly aint same as IR-Blaster in most cases
ir-blaster being more powerfull led usualy
@Deleted User what phone
so
whats the non-meme reason for Red Hat/Canonical's hard on for Gnome?
gnome sucks my penor in every way I can imagine
why not ? if it works and has better support than others ? why switch
and switching whole codebase to some random new thing from gnome would take years
and introduce many bugs
and possible breaks we havent heard of on production side of things
just making all the tutorials,training videos etc broken by switching to different thing would break and lose many customers
@Tervy pocophone
yeah but you can use inertia to justify any stagnation.
the cost of moving from fax to email in the business environment was probably very high
most likely said move brought more benefit than costs
unlike breaking workflow and visual look of thousands and thousands of users
ye
@Deleted User did some digging and apparently the porcophones "ir" led is only used for facial rego and does not provice actual IR-port option out of the box
BUT if you contact some custom rom nerds i bet enabling that IR-led hardware to send user-controlled pulses can be done (on side note apparently lineage os has yet to get that ir-camera working properly but dunno if that is camera + led or just the camera controls what are buggy currently)
and as its not "proper Blaster" more like wide angle smd led its range can be low
Yeah I noticed it burning when i did the face rego
I'll probably just keep one of those .40$ pins around. Also makes for a nice gift
>linux is awful on HiDpi 4k screens
why didn't anyone tell me this
it's not?
solus has great HiDpi scaling
KDE and kwin in general have the best hidpi support
kwin is the only one with proper fractional scaling
"its not bad, its unimplemented"
>connect two displays on windows and use a different res on each
>one of them is blurry
t-thanks
>the only way to fix it is to use a 3rd party software
>connect two screens to two different gpus under x11 on Linux
>try to move window from one screen to the other
11,181 total messages. Viewing 250 per page.
Prev |
Page 6/45
| Next